Description

Waterjet Pump Parts High Pressure Cylinder CP022009-779 Waterjet Pump Parts Waterjet Spare Parts for Waterjet Cutting Machine

FAQ for Waterjet Cutting Machine and Waterjet Pump Parts:

Fault: The sand conveying pipe backwaters and cannot seal the water
Solution: Replace the water switch seal assembly
cylinder unscrewed
Cylinder: Actuator Pressure screw: on/off valve screw Water seal assembly: on/off repair kit Water switch valve body: on/off valve body Water switch valve pad: seat Water switch valve pad O-ring: O-ring, water switch Adapter: adapter

Note: When replacing the sealing assembly of the water switch, it is not necessary to disassemble the valve body of the water switch, and the sealing assembly of the water switch can be directly replaced on the platform, which can prevent water leakage during reinstallation.
Disassembly: Unscrew the cylinder on the left, unscrew the pressure screw, unscrew the water switch adapter on the right, take off the O-ring, take off the water switch valve gasket, and then push the water seal assembly from right to left with the tool. Remove the water seal assembly
Installation: Apply lubricating oil to the new water seal assembly on the left and gently push it into the water switch valve body as shown in the figure (only a little goes in at this time) and then tighten the pressure screw (note that the pressure screw is anyway, the plate mouth is outside), Install the new water switch valve gasket on the right side (regardless of which), install the O-ring, install the water switch adapter, and then install the cylinder.