500-20-0113 Outlet Poppet waterjet consumables

Catégorie:

Description

Outlet Poppet 500-20-0113 waterjet consumables

Knowledge for waterjet cutting machine and waterjet consumables:
1, Before turning on the cutting head of the machine every day, put the cutting head in the empty space of the cutting table, from low-pressure water to high-pressure water, manually tap it first, observe the working condition of the machine, whether there is sand blockage, water leakage or other conditions, if All is good, just proceed to cutting work.
2, Have you adjusted the working pressure of the pump? We have adjusted the working pressure of the pump before leaving the factory. You can’t increase it any more. The working pressure of the pump is usually before 16-18mpa. If it is higher, it will affect the function and service life of the pump parts waterjet consumables.
3, In addition, one of the necessary conditions for the pump to work is that the inlet water pressure must be above 0.4mpa, please check whether the pressure is insufficient.

4, You can turn on the intensifier pump directly when you turn the machine on, and observe the working state of the machine, because the oil pump can only run when the refrigerator is working in the intensifier, and the hydraulic oil can circulate, and then the hydraulic oil and water can exchange heat.
It is normal below 35 degrees. When the intensifier pump is working, please observe whether the oil and water are in normal circulation and replacement.