Descripción

CP022018/563 Flansch Flange Art Water Jet Spare Part for waterjet cutting machine

FAQ for waterjet cutting machine and water jet spare part:

1: Water Jet Spare Part trivia:
1.1 Water Jet Spare Part On/off valve repair kit/pneumatic valve repair kit with maintenance kit / waterjet cutting head assembly: it is recommended to be installed before shipment, so that customers can use directly after receiving the goods
1.2 Water cutting equipment Water Jet Spare Part shipped should be coated with anti-rust oil, although most of the water cutting parts are made of stainless steel and brass, but in the process of transportation, at sea, there is a certain amount of moisture and saline line is not the same, will cause there to be water rust, coated with anti-rust oil will protect the parts .
1.3 Water jet cutting Water Jet Spare Part accumulator needs to be pressurized before shipment, in general, the equipment working pressure in the case of 320MPa, the accumulator test pressure at 450MPa, the normal working pressure of the equipment in the case of 550MPa, the water jet cutting accumulator test pressure at 680 MPa, the test time is the first half hour, 24h apart again test time one hour, the shipment of When you need to use a wooden box, you also need to put a soft protective device, in the screw position to apply lubricating oil
1.4 Water jet cutting equipment drive, when buying the drive need to pay attention to the drive is required to adjust the correct parameters before use, so customers need to consult when buying the drive debugging parameters, whether the manufacturer debugging or customer debugging, this needs to be determined, water cutting drive without adjusting the parameters can not be used.