What is the distance between the water jet cutting head of Water Jet Supplier and the cut material?
The distance between the water jet cutting head of Water Jet Supplier and the material to be cut is usually specified by the manufacturer of the cutting head of Water Jet Supplier or the manufacturer of the water jet cutting machine of Water Jet Supplier. Generally, this distance can be adjusted for different cutting materials and requirements.

During the cutting process, the depth and angle of the cut material varies, and the distance between the cutting head and the material needs to be adjusted in time according to these, this is categorized into manual and automatic, depending on the configuration of the machine. If the distance is too close, the cutting head may rub and wear against the material, affecting the cutting effect; if the distance is too far, the cutting speed and efficiency may be reduced.

Generally speaking, at the beginning of cutting, the distance between the cutting head and the material surface should be about 3-6 mm, and the specific distance can be adjusted according to the hardness and density of the material. During the cutting process, it needs to be adjusted according to the actual situation in order to maintain the best cutting effect and speed.

When carrying out water jet cutting, you need to pay attention to safety, comply with relevant operating procedures and standards, and wear relevant protective equipment.