1004146 Waterjet Hydraulic Cylinder Waterjet Cutting Parts

Category:

Description

Waterjet cutting parts Hydraulic Cylinder

Item number: 1004146

1027347Valve body
1004604Check valve assembly
1003551Hydraulic piston
1003544Hydraulic cylinder
1003644Filter Housing
1003433Check valve adapter
1004146Hydraulic cylinder
1001653High pressure seal ring
1009700Coupling
1003302High pressure filter
1004541Check valve repair kit
1004386Piston retaining ring

FAQ of waterjet cutting machine – How to adjust the verticality of the AC five-axis waterjet cutter head?

The waterjet head is a waterjet cutting parts mainly used to cut various materials. The cutting accuracy of the waterjet is very high, but if the verticality of the head is not accurate, it will have a serious impact on the cutting quality. Therefore, for waterjet users, adjusting the verticality of the cutter head is a very important skill.
To adjust the verticality of the waterjet cutter head, you need to pay attention to the following points first:
1. First of all, it is necessary to confirm the structure type of the waterjet tool. Different types have different verticality adjustment methods. For example, for a three-axis waterjet cutter head, verticality adjustments can be made through the adjustment screw on the waterjet machine. For other tools, it may be necessary to use adjustment pads or other auxiliary tools for adjustment.
2. Secondly, it is necessary to check whether the components of the waterjet tool are loose or worn. If so, they need to be repaired or replaced first. Loose or worn parts may prevent the cutter head from being adjusted correctly.
3. Finally, before adjusting the cutter head, it is necessary to completely shut down the waterjet machine and cut off the power, and wait for the cutter head to cool down to ensure the safety of the operator.
When making specific adjustments, you can follow the steps below:
1. Put the tool on a completely stable plane, and confirm that the tool is completely parallel to the contact surface of the plane.
2. Locate the adjustment screw or other adjustment component on the tool and loosen it. The AC five-axis water cutting head needs to adjust the verticality of the cutting head in the system
3. Use a blade or other vertical tool to place on both sides of the cutter head. Then, by gradually adjusting the screw or other waterjet cutting parts, the blade can directly touch the sides of the cutter head and be parallel to it. Repeat this step until the blade is in direct contact with the cutter head at all points and is placed vertically above a horizontal surface.
4. According to the adjustment results, make corresponding fine-tuning until the cutter head can cut the surface of the workpiece vertically to ensure high-quality cutting results.
In general, the adjustment of the waterjet cutting parts and the verticality of the waterjet head requires caution and patience. Accurate adjustments and high-quality cuts can only be achieved if the tool type and components are known.
We have lots of waterjet cutting parts in stock, if you are looking for waterjet cutting parts supplier, welcome to contact!